canyon-ep403draft

Replacement for the Canyon EP403-16 "Leitungsführung" (part E403-16), the small plate under the bottom bracket that covers the frame's cable port. A slit with a keyhole at its end lets it slide over a hose that is already in place; two small screws hold it. Canyon lists it as sold out, without dimensions or a list of frames (product page; it is also part of the GP7067-01 cable routing kit, "for all Canyon AL frames with special designed clip loops").

Status: draft. The outline and the bend come from a friend's Solid Edge sketches of his original (2026-11-08); params.py marks every number as MEASURED (his), ESTIMATE (read off his screen photos) or PLACEHOLDER.

This is a personal project, not affiliated with or endorsed by Canyon Bicycles; "Canyon" and the part numbers only say what the part is meant to fit. It has not been printed or fitted to a bike: use it at your own risk.

Open questions (for whoever has the original)

1. Thickness (placeholder 2.0 mm).
2. The two screw holes: positions, diameter, screw size, or none at all (placeholders: Ø 2.2, 6 mm from the slit end, 5 mm either side of the slit).
3. The 37 mm length: measured straight across, or along the curve? The model reads it as straight across; along the curve, the part would be about 2.5 mm too long in projection.
4. Slit width at the keyhole and at the end (estimates 1.0 and 2.7 mm).
5. Which side touches the frame: the model takes the sketched curve as the inner (frame side) surface, with the thickness outside the bend.
6. Which bike.

Print sheet (suggestion)

The 3MF comes lying on its right side, which is flat: the bend is printed in the layer plane, true to shape, with no supports, and the layers run along the slit's two fingers.